FAQ
2. If without program switch, how to do with
1. Take a wire to connect port 1 to port 6 of main control board, This is same function with set program switch to
3. How to connect the sensors?
A: Outside sensor connect to port 14 & 16 of main control board, inside one to 17&19.
Other questions
1. How to proceed the learning circle for ES200 a. A. Move the panel to half open position b. Set program switch to “close” c. On power, should close slowly d. Start learning cycle when panels is close e. Start learning cycle, press “SERVICE”(The Red button), release the button when door leaves moving open slowly, … Read more